Nixon: Super Hero II SS Watch

This watch might just be the all-in-one accessory. All the technology advances without looking like a minature computer. To read the tide height: The tide is graphically represented with the crescent shape that is thicker at the 12 o’clock position and thinner and the 6 o’clock position. High tide can be recognized when the tide hand is at the 12 o’clock position. Low tide can be recognized when the tide hand is at the 6 o’clock position. As the tide moves from 12 to 6 the tide will be falling. As the tide hand moves from 6 to 12 the tide will be rising. About Tides: Working on average tide sequence of 12 hours 25 minutes and 14 seconds from high tide to high tide, the watch will help you accurately plan your surf breaks around your busy work schedule. Depending on your location you may have to reset your watch to keep your reading accurate.

• Movement: Custom analog/digital with pre-programmed tide charts for 200 beaches until 2020
• Dual time
• Alarm
• Countdown timer
• Wave counter
• Chrono and light
• Case: Custom 100 meter titanium with hardened mineral crystal, raised bezel and triple gasket crown. Case rating of 100 meters will allow for rain, and or water splashes up to activities such as surfing, snorkeling and spear fishing. Watch can be fully submerged up to 100 meter depth. Wash watch with soap and water after exposure to salt water or sand.
• Band: Custom Polyurethane
• Setting the Time: Some watches come equipped with a screw down crown. The crown must be unscrewed by turning it counter-clockwise before you can pull the crown out. PULL the crown to so that it pops out from the frame of the watch (the stem of the crown should not be showing), TURN the crown either direction to the correct time, and PUSH the crown back in towards the frame.
• Setting a Date Window: PULL the crown all the way out so that the stem of the crown is showing, then PUSH it back halfway so that you are still able to twist it but the stem is no longer showing. TURN the crown towards you (counter-clockwise) to the correct date. Push the crown all the way back in. NOTE: The date will automatically update every 24 hours. HINT: To make sure that the date is updated at midnight instead of noon, set the date before noon.
• Setting a Day / Date window: PULL crown all the way out so the stem can be seen, PUSH it back in halfway. TURN crown away from you (clockwise) to the correct day. TURN crown towards you (counter-clockwise) to the correct date. PUSH crown all the way in. NOTE: The day / date will automatically update every 24 hours. HINT: To make sure that the date is updated at midnight instead of noon, set the date before noon.
• Setting the Alarm: PULL the alarm switch out. PULL the crown out halfway. TURN the crown to set the alarm time. PUSH crown all the way in. When the alarm is set at 4:00, the alarm will sounds for 20 seconds at 4:00 in the afternoon and 4:00 in the morning. So turn it off after is sounds at 4:00 PM, unless you want to wake up at 4:00 AM as well.
• Chronograph Reset: This procedure should be performed when the chronograph second hand does not return to the 0 second position after the chronograph has been reset. You may also have to reset the chronograph after the battery has been replaced. PULL the crown out. PRESS the start/stop button to set the chronograph second hand to the zero position. PRESS and hold the start button to rapidly advance the chronograph second hand. NOTE: Don’t push the crown back to position while you are returning the second hand to the 12 o’clock position.
• Heat / Countdown Time: ROTATE bezel so desired countdown time increment aligns with minute hand in it’s current postion. WATCH as minute hand counts down to the highlighted zero maker